![]() You can configure it here, so you can control the projector through the computer. PINK - This area is if you have a USB/Serial enabled projector. This will add it to the Configured Displays list. To pick your display, find it in the list, select it, and click the plus button. To remove parts, select the minus button. The current one listed is just my laptop screen currently. You will need to have your projector plugged in at this point, or it won't show up on the list. PURPLE - This lets you select which display you want to shine the picture is on. It gives you the accuracy based on your projector resolution and your build size. ![]() In the case of the LiteFab, it would be the port that the Arduino with GRBL installed is on.īLUE - This is just an informational window. GREEN - This is the port that connects to your controller. If you print a model that is 20mmx20mm, and it comes out 19.2mmx19.7mm, this button will auto-calculate the adjusted build size to get your model to print out at 20mmx20mm. The adjust button will allow you to fine tune your build size. ORANGE - Applies any changes you have made to the currently selected machine (in RED) ![]() RED - This lets you add new machines, or delete ones. ![]() Below is described what each section is, corresponding to the colors on the image. In this window, there are several sections used for configuring your specific machine. We'll start with how to configure your machine.
0 Comments
Leave a Reply. |